|
|
The atilibusb driver offers support for many RF devices sporting usb receivers with the X10 chip, Some of these are X10 branded, other sold under names such as ATI or Medion.
Typical dmesg output for hotplugging such a device:
usb 3-1: new low-speed USB device number 23 using xhci_hcd usb 3-1: New USB device found, idVendor=0bc7, idProduct=0006 usb 3-1: New USB device strings: Mfr=1, Product=2, SerialNumber=0 usb 3-1: Product: RF receiver usb 3-1: Manufacturer: X10 WTI
The driver conflicts with the linux atiusb kernel module. Thus, to use atilibusb the kernel module must be blacklisted. This can be done with a file named e. g., /etc/modprobe.d/lirc-blacklist with the following content
# blacklist drivers which conflict with lirc userspace drivers.
blacklist ati_remote
blacklist lirc_atiusb
The module autodetects available devices and a --device argument is normally not required. However, if given an existing device as argument this will be used. It has support for enumerating available devices e. g., using mode2 -l .